Omega Smart Canopy - 'Top Triangle' In-Fill Section for Sides of Canopy, 16mm Polycarbonate In-Fill Panels, White Frame

Top Triangle In-Fill section in 16mm Clear Polycarbonate

This ‘Top-Triangle’ In-Fill can be fitted to Omega Smart Lean-To Canopies with a projection between 1.5m and 4.5m.

On completion of the Canopy installation we will ask for (3) pieces of information:

1. The Canopy Roof pitch.
   This will be required to an accuracy of +/- 0.1 degrees.
   This is quite difficult to measure with normal household equipment so Omega will supply a digital protractor to enable the roof pitch to be measured.
2. The distance from the wall that the canopy is mounted on to the inside face of the end supporting post.
3. Whether the In-Fill section is on the Left-Hand or Right-Hand side of the canopy.

Our installation guide gives clear instructions that show what these angles/dimensions are and how to measure them.

With this information Omega will manufacture the In-Fill section components that will allow a straightforward installation that is made-to-measure.

The prices assume a standard installation where the base frame of the Top Triangle In-fill is located directly under and adjacent to the bottom edge of the Eaves/Gutter.

Prices are for (1) Top Triangle In-Fill section (for (1) side of the canopy).

The In-Fill section frame is structural T6 aluminium alloy, powder-coated in (Hipca) White, RAL9910 (Gloss).
The glazing panels are supplied in 16mm Clear, Bronze or Opal Polycarbonate.

If you require the In-Fill section frames in a colour other than White please contact Omega for a quotation.